Legos
Printed From: Pixel Joint
Category: Pixel Art
Forum Name: WIP (Work In Progress)
Forum Discription: Get crits and comments on your pixel WIPs and other art too!
URL: https://pixeljoint.com/forum/forum_posts.asp?TID=19790
Printed Date: 06 April 2026 at 5:00am
Topic: Legos
Posted By: Froste
Subject: Legos
Date Posted: 17 September 2014 at 11:41am
Made a few lego piece while working on AA and edge work. Let me know what yeah think.  Also, if these legos work, can i build a lego creation the lego has put out and post it on here? |
Replies:
Posted By: felchqueen
Date Posted: 17 September 2014 at 12:30pm
|
I think you should take the top line of pixels off the Lego bricks and take a pixel off either end of the next line down to put the stud into better perspective, but otherwise nice work. As for the Lego figure the arms need to be bigger as does the head. |
Posted By: Froste
Date Posted: 17 September 2014 at 12:37pm
|
Originally posted by felchqueen I see what you are saying and that would make sense.I think you should take the top line of pixels off the Lego bricks and take a pixel off either end of the next line down to put the stud into better perspective The head has been giving me a lot of trouble, i try to make it big and it doesnt seem to fit to well. i will keep trying to tweek it till i get it right. Thanks |
Posted By: felchqueen
Date Posted: 17 September 2014 at 1:03pm
|
Looking at images online, the head is almost the width of the shoulders, I'd say just about where the yellow of the V on the front hits the shoulders and the height is almost the size of the body. Here's a rough guide for the head  |
Posted By: Froste
Date Posted: 18 September 2014 at 12:24pm
| either that or the top of the body is to wide. it shrinks as it goes up. I will have mess with it to see what works best. |
Posted By: Limes
Date Posted: 18 September 2014 at 9:37pm
| Gotta fix the Trex arms. |