Pixel Joint Forum: creating isomtric lampost

Message

   hi im having difficulty on the curve of lampost and keeping the lines correct . 

i have the isomtric square correct on the lid above the  light of the lampost   
correct. However its the curved part the spine of the lampost which i am finding difficult.

http://fav.me/d563z3w

Author	Message
hansolo Seaman Joined: 16 February 2009 Location: United Kingdom Online Status: Offline Posts: 13	Topic: creating isomtric lampost Posted: 04 July 2012 at 2:41pm
	hi im having difficulty on the curve of lampost and keeping the lines correct . i have the isomtric square correct on the lid above the light of the lampost correct. However its the curved part the spine of the lampost which i am finding difficult. http://fav.me/d563z3w
	IP Logged

yrizoud Commander Joined: 03 May 2021 Location: France Online Status: Offline Posts: 343	Posted: 04 July 2012 at 4:35pm
	In step 2 your left slope "breaks" from the line . The curve should start from a tangeant instead. (well, if the curve was not intended to have a break, anyway) Step 3 has a bigger issue: the left side ends on top instead of staying on the side. Edited by yrizoud - 04 July 2012 at 4:37pm
	IP Logged

hansolo Seaman Joined: 16 February 2009 Location: United Kingdom Online Status: Offline Posts: 13	Posted: 05 July 2012 at 2:40pm
	cheers commander you right. Ive changed my method now . I created a line by creating isometric grid on the side . I applied illustrator round corner to a stoke .Which does seem to be correct now How ever i would like to know how to manually draw this tangent curve for the lamp post on the side grid.. if any can rather thann using my method thanks http://fav.me/d568fdt Edited by hansolo - 06 July 2012 at 11:37am
	IP Logged

Resources and Support
Pixel Joint Forum : The Lounge : Resources and Support